10
To replace the lining,
place the bosses over
their plastic receptacles
and push them home
⑤&⑥
.
WARNING:
When reinstalling the comfort lining, be sure the lining is
properly positioned along the inside shape of the EPS (a.k.a. Styrofoam)
liner. If the comfort lining is not properly installed, the frame of the comfort
lining may fold when you put on and take off the helmet, which may injure
your skin, etc. Whenever you feel something is wrong with the comfort
lining, check that the lining is properly installed.
To remove the chinstrap covers, first remove the cheekpads as per
previous instructions.
Remove the plastic chinstrap
anchor cover from the steel
chinstrap anchor
①
.
Slide the cover off the chinstrap
②
.
TO REMOVE/REPLACE CHINSTRAP COVERS
Left chinstrap cover (D-ring side)
Right chinstrap cover (long side)
To replace the left chinstrap cover (D-ring side), ensure the female chinstrap
end snap side of the chinstrap and the leatherette side of the chinstrap cover
both face outward, slip the chinstrap cover onto the chinstrap
①
.
Position the plastic chinstrap anchor cover over the steel anchor and push the
cover in the anchor until the tab on the back of the cover snaps fully home
②
.
To wash the chinstrap covers, put them into lukewarm water with small
amount of laundry soap or your own shampoo and wash gently by hand. Rinse
well with fresh water and wipe off with a soft cloth. Dry them in the shade at
ambient temperature.
WARNING:
Never use petrol, thinner, benzene or any other solvents.
NOTE:
The right and left, inside and outside of the chinstrap covers for
replacement.
⑤
⑥
①
②
①
②
