3
Introduction
A.
Filter cartridge (Filter in the picture may
B.
look different)
C.
Filter upper covering
D.
Filter lower covering
E.
Housing
F.
Switch lever
G.
Steel mesh
H.
Silicone washer
I.
Adapter assortment
J.
Attachment nut
K.
Multi-function adapter
L.
Key
M.
Silicone gel washer
This product can filter out particles and impurities, such as suspended solids, colloids, sand, rust and other
solid impurities. Effectively remove the residual chlorine in water, some organic matter and heavy metals.
Providing safe and healthy water for washing, cooking and drinking, also it provides clean water for your
face cleaning, teeth brushing, etc.
Replacing the cartridge is easier than replacing the bulb.
Preparation for use
Before using
•
This product is suitable for municipal water supply, unknown water source only with caution.
•
The tap water pressure must be between 0.1-0.4Mpa. If you use the water purifier at a water
pressure outside this range, the water purifier may get damaged. If needed, install pressure limiting
valve on the water inlet pipe to avoid excessive pressure.
•
Before you install the water purifier, make sure all tap-mounting adapters you require are present.
•
The tap must have a diameter of 20mm-24mm, determine what type of tap you have and select the
appropriate adapter. Water purifier may not fit some uncommon types of taps. In this case, it is
possible to find other adaptors from hardware stores.
Cautions
•
Please do not touch the purified water outlet, to avoid bacterial growth. Note, purified water does
not have chlorine for disinfection of bacteria. It is not recommended to store purified water longer
than one day.
•
Please flush the new cartridge for 60 seconds before start drinking filtered water.
•
Let the water run thru the filter for 10 seconds before use each day, in order to discharge the
retained water. Let the water run thru the filter for 60 seconds before use, if you have not used
the water purifier for more than two days.
•
This product is suitable for water temperature between 5 and 38 °C. Please do not install near the
flame or high temperature to avoid deformation or rupture, which could cause failure and leakage.
Too hot or cold water can cause damage to the replacement filter. If you accidentally use too hot
water, flush the filter with normal temperature water for 20 seconds.
J
A
K
H
L
I
H
G
E
I
F
D
