Aquatronica ACQ210-D, Instruction Manual

Page: 10 / 16

IsACQ210D-0 Rev. 250907-2 10 - 16
Via dell’Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: service@aquatronica.com
About
Provides information on the control unit’s firmware ver -
sion. To use this function, proceed as follows:
Main screen

Main menu

Density

About.
Disconnect
If the density interface is disconnected, a message
will appear on the display (Fig. 21). Press “ Enter ” to
indicate that the message has been read.
On the main screen the “ ? ” icon will appear next to
the name of the “ Density ” sensor and in the lower left
corner (Fig. 22).
If the conductivity interface is reconnected, the con -
trol unit will automatically begin displaying the read
value again.
To definitively eliminate the density sensor from the
system, after disconnecting it, proceed as follows:
Main screen

Main menu

Density

Disconnect.
The “ Data Record ” and “ Calibrate Sensor ” functions
disappear from the “ Density ” menu (Fig. 23) and the
“ Disconnect ” function appears.
• Select this function using the

keys and press
“ Enter ”.
• The disconnection screen will appear (Fig. 24). Press
“ Enter ” to disconnect or “ Esc ” to cancel.
(Fig. 21)
Device
Disconnected
S01: Density
(Fig. 22)
Mon 11/06/07 15:05
PU01 A B C D E F G H
Density ?.?
English
(Fig. 23)
Density
Change Name
Programs
Alarm
Measurement Unit
Disconnect
(Fig. 24)
Disconnect
Density
Enter: Confirm
Esc: Cancel
(Fig. 20)
Aquatronica
FW version: x.y
Press any key to
continue