3
NOTE:
Most sinks are pre-drilled with a 1 ¼"
diameter hole that can be used for the faucet.
If your sink does not have a hole, you will need
to drill one.
w w w . a q u a t i c l i f e . c o m
NOTE:
If your model includes
rubber plugs on any of the ports,
it is now OK to remove the plug
by simply pulling it out of the
press fitting.
MOUNTING THE FILTRATION UNIT
The Aquatic Life TI Filtration Unit is designed to be
mounted to a secure surface. This will allow for the
cartridges to easily be replaced as needed.
The TI Module includes a metal bracket with screw holes
for easy hanging.
Use screws designed for the type of surface that the
TI Module will hang on. Once the TI Module is hanging
on the screws, tighten the screws to secure the TI Module
to the surface.
FAUCET INSTALLATION
The faucet may be installed on any flat surface.
Always check the underside of the desired location
to make sure it is clear of obstructions.
Step 1
– Determine the desired location for your faucet
on your sink surface.
Step 2
– Place a piece of masking tape on the sink to
determine hole location. Mark the center of the hole to be
drilled on the tape.
Step 3
– Use a variable speed drill on low speed to drill
an
1
/
8
" hole in the center of the marked location.
Step 4
– Enlarge the hole using a
¼
" drill bit followed by a
½
" drill bit. Using the different size bits to enlarge the hole
will make it easier to achieve the final
½
" diameter hole size.
Step 5
– Assemble the faucet
as shown in the diagram.
CAUTION!
Once drilled, the hole in the sink
might be sharp. Use caution when inserting the
faucet stem into the hole.
Chrome
Plate
Model: 540372
Twist-In 2-Stage Water Filtration Unit
Installation, Operation & Maintenance Guide
Rubber
Washer
Plastic
Washer
Lock
Washer
Hex Nut
Insert
Tubing
Sleeve
Hex Nut
Sink/Counter
