Aquatic 9
LuxeAir Series Owner's Manual & Installation Guide
INSTALLATION PROCEDURES FOR INTEGRALLY SKIRTED MODELS
1. To avoid obstructions during installation, make sure water lines, spout pipes and valve plumbing do not project into
alcove.
2.
Ledger Strip:
Fasten a 1” x 3” (25mm x 75 mm) ledger strip along rear for alcove and along both sides in corner
installations at Dimension LH. (see Figure 3A)
3. Place three or four mounds of mortar away from drain hole in a line or square, approximately twice as high as the
cavity under the tub bottom.
4. Place tub into alcove with front skirt firmly on floor and depress mortar mounds. Make certain that back ledge of tub
rests firmly on ledger strip. (see Figure 3A)
5. See and follow
Sealing & Finishing
Figure 3B.
REMOVABLE SKIRT PANELS FOR INTEGRALLY SKIRTED MODELS
These models are offered with removable panels. It provides a flush-to-
wall installation (sheet rock overlaps skirt while still providing access).
The skirt features a decorative removable panel enabling easy access
to motor, pump, blower and electrical hookups. Clips enable simple
and quick removal of skirt access panel.
Important: Before installation of the panel, fill the unit, test the
whirlpool system for proper operation and check for leaks, then drain.
INSTALLATION INSTRUCTIONS
3A
Framing
Dry Wall
Figure 4
Right Side Edge
Clips
(back of panel)
Panel
Left Side Edge
Integrally Skirted Acrylic Whirlpool
3B
Sealing & Finishing
Typical methods of sealing and finishing
Make sure interior of tub
is protected during finishing
Summary of Contents for LuxeAir Series
Page 31: ......
