12 Aquatic
Serenity Owner's Manual & Installation Guide
FACTORY INSTALLED TILE FLANGE
1. Install the air bath unit per the instructions provided in this manual.
CAUTION: THE TILE FLANGE DOES NOT
SUPPORT THE TUB!
A ledger board must be provided under the bath rim as indicated in the installation instructions.
Take care to ensure tub is not hanging from the ledger boards, as this will void your warranty.
2. Use nails or screws to secure the flange into the studs around the bath.
3. Install water resistant drywall against the tile flange and fl
ush to the top of the air bath deck. Install the tile or other
finishing materials. Apply a second bead of silicone
between the first course of tile and the bath deck.
NOTE:
Before tub is used, the air bath system should be
cleaned in accordance with the procedures on Page 32
of this manual.
INSTALLATION INSTRUCTIONS
PLUMBING
1. After securing tub in place, normal waste and overflow, water spout and valves are installed per normal plumbing
procedures, in accordance with all state and local standards.
2. Install standard 1-1/2” trap to drain and overflow. Before proceeding, make final operational check by filling tub with
water to overflow and operate blower for 5 minutes. Carefully check for leaks both while blower is running and after
it has been turned off. Allow water to stand in tub for at least 30 minutes before draining. AQUATIC WILL NOT BE
RESPONSIBLE FOR WATER DAMAGE OF ANY KIND.
3. When selecting fill spout location, check to ensure that spout is long enough to clear the tub rim from its desired location.
If installation is to be on the tub deck, check the back side of tub for adequate space for connection to water lines and
that there are no air channels running under that area of the tub rim before drilling or cutting tub.
4. A service access panel of a minimum of a 16” square must be provided adjacent to blower and control box assembly.
Note: For rough-in measurements please refer to the unit’s technical data sheet.