Press the ON/OFF button.
Red Light: Power to the docking station is ON, but the unit is in standby mode.
Blue Light: The unit is powered ON and looking for an audio source.
For applications that require low current draw and where battery drain may occur, the power but-
ton must be turned OFF inside the unit. When the power button is in the OFF position the red
LED will not be lit.
For applications where a 12V battery is not used, such as in a Spa, the power button can be left
ON and the remote control or door controls can then be used to power on/off accordingly.
For detailed instructions you can check out our online video:
‘How to wire your Aquatic AV stereo system’
http://www.aquaticav.com/support/videos
1.7 Power On
1.6 Power Attenuation Wires
The output power of the Digital Media
Locker is factory set at -3dB below the
nominal power but can be changed to
suit different applications. The factory set
output level of -3dB should be used to
avoid blowing very small speakers, often
used in spa applications.
By cutting only the white wire the output level will decrease to -6dB below the nominal 0dB.
By cutting both the white and black wires the power/volume will increase to +6dB above the
nominal 0dB.
By cutting only the black wire the power/volume will increase to +3dB above the nominal 0dB.
These modifications should only be carried out by an experienced audio installer.
Black Wire
White Wire
Output Level
Intact (not cut)
Intact (not cut)
-3dB
Intact (not cut)
Cut
-6dB
Cut
Intact (not cut)
+3dB
Cut
Cut
+6dB
Should you cut the wrong wires or wish to reconnect them to further alter the attenuation, the Power Attenuation
Wires can be crimped back together.
Getting Started
Digital Media Locker AQ-DM-6UBT
7
www.aquaticav.com
