Aquathin AquaKING RO, Owner'S Manual

Page: 43 / 52

43 © 2009 Aquathin Corporation. All rights reserved.
You can obtain specifics about your water supply from
either your local water department or your local
Authorized Aquathin Dealer. If the parameters of your
water do not fall within the specified ranges as noted
above, please contact your local Aquathin Dealer for
further treatment options. Production is rated at optimum
temperature of 70° F, 60 PSI, and 500 ppm TDS. Actual
production will vary depending on local temperature,
pressure, and TDS level.
Low tap water pressure will reduce the volume and
quality of the water produced by your system. In low
pressure situations (<45 PSI, 3.1 bar) RO/DI values
cannot be assured. The addition of a booster pump (PBA-
AK) is strongly recommended.
ALWAYS USE COLD WATER—hot water will damage
the TFC membrane.
The unit must not be allowed to freeze. Freezing water
will expand inside the modules—damaging the
membrane and potentially rupturing the filter housings.
Damage of this type will void the Warranty.
This system has been tested according to WQA S-300 for
reduction of TDS. The concentration of TDS in water
entering the system was reduced to less than or equal to
the permissible limit for water leaving the system, as
specified in WQA S-300. Testing was performed under
standard laboratory conditions. Actual performance may
vary. Follow installation procedures and scheduled
maintenance for optimum performance.