Component Checklist
INSTALLATION
3
IMPORTANT!
Before starting any installation ensure that ALL POWER has been switched to the OFF
position at the MAINS of the installation location. Should you ever doubt or have questions regarding this or
any part of the installation process contact a professional electrician or
audio/video installer. Never attempt
installing this produce if you do not have the experience or do not understand the instructions.
Never install your Bluetooth Ceiling Speaker in an area where electrical wires exist!
1.
Using a tape measure and the included CUTTING TEMPLATE mark the location and area of wall surface
that will be cut out. Use a stud finder to ensure there are no obstructions located behind the area you will be
mounting your speaker. You can use painters or masking tape to hold your template in place prior to actually
cutting into the surface. Use a standard pencil trace the inner area of your CUTTING TEMPLATE marking a
circle area that will be removed.
4.
Insert the speaker into the cut-out hole and using a screwdriver lock the 4 dog leg tab mounts securing the
speaker in place. Do not forget any dog leg tab mounts or over-tighten during installation. Once secured,
attach the magnetic grill to the front of the ceiling speaker.
4
2.
Drill a pilot hole into the center of the CUTTING TEMPLATE. Using a standard cutting saw carefully insert
it into the drilled hole and begin sawing a line to the outside area of the template while making sure you do
not go outside the penciled circle area. Take caution to keep your fingers away from the cutting blade and
always wear eye protection.
3.
Connect the Power lead from the supplied power supply into the Power Input found on the rear of the
ceiling speaker (noted on diagram). While installing the power, do not overstretch, kink, or pinch the wire.
