7
INSTALLATION INSTRUCTIONS
TECHNICAL SPECIFICATIONS
SPKMove70-W
Model
RMS Power
Impedance
Sensitivity (1W/1m)
Type
Woofer
Tweeter
Bluetooth System
Wireless Range
ID Device Name
Frequency Response
Up to 10 metres
BT Speaker
AC Supply: AC 100-240V, 60/50Hz, 2A
DC Input: DC 24V, 2.5A
60W (30W Master / 30W Slave)
8 Ohms
90dB
Class D (Digital)
0.75" Titanium Cone
Bluetooth V4.0
6.5" Kevlar Woven Cone
60Hz-20kHz
TROUBLESHOOTING
If you have any questions or problems during the installation and operation of the Bluetooth Ceiling Speaker
please refer to the troubleshooting help found below. Should your question or problem not be solved please
contact your place of purchase.
NOTE:
Please observe proper electrical wiring standards and should you doubt your understanding or have
questions please consult a professional installer. ALWAYS switch power to the OFF position at the
electrical MAINS powering your installation location prior to installation or troubleshooting.
Q:
The Bluetooth Ceiling Speaker is not found during the Bluetooth pairing process.
A:
Check the unit to ensure it is connected to power and that all wiring is correct.Check to see that the
blue/red LED light found on the outer ring of the speaker is flashing. Press and hold the RESET button for 5
seconds. This will reboot and reset your Bluetooth Ceiling Speaker.
Q:
Speaker fails to connect to the Bluetooth device.
A:
Refer to the Connection Reset Button found above and retry the pairing process. Should the device
prompt you for a password key in 0000 and pairing should complete. Ensure your Bluetooth device is within
5-10M of the Bluetooth Ceiling Speaker location.
Q:
The Bluetooth device is connected to the Bluetooth Ceiling Speaker however there is no sound.
A:
Check all signal wiring for proper connection and that there are no kinks or breaks in the wire. Adjust
volume up and check to ensure that your device is not muted.
Q:
Can the Bluetooth Ceiling Speaker be installed into a bathroom ceiling?
A:
Unless you have purchased an IP-rated model (weather/dust/moisture) you should avoid installing the
Bluetooth Ceiling Speaker in areas that will be in contact with moisture or higher than normal humidity.
User Manual
SPKMove70-W
BLUETOOTH CONNECTION RESET BUTTON
Bluetooth Speaker
Power Requirements
Press and hold the RESET button for 2 seconds. The RESET button is located on the outer ring of the
Bluetooth Ceiling Speaker. Once reset all previously paired devices will be removed and the speaker will be
ready to pair with any new Bluetooth enabled device.
Aqua Sound
