6
Configure System
Fit Rhino tank and additional optional
add-ons into the system at this time.
Screw Pre-Filter and Post-Filter support
brackets onto the wall and attach filters.
Properly connect system together
accordingly (slip fittings, barbed fittings,
NSF certified PVC glue, etc.). Ensure all
parts are flowing through the "IN" port
in the correct direction of water flow.
Final System Check
Once installation is complete, allow proper time for glue to dry according
to manufacturer instructions. Then, slowly turn water on and inspect
for leaks.
After inspecting for leaks, turn on the faucet closest to the installed unit
and allow water to run for 5-10 minutes for the final flushing period.
7
8
INSTALLATION STEPS
Incoming
water supply
Outgoing
water supply
Install Shut-off Valve and Ensure Spacing
(Cont. from previous page)
5
Ensure proper spacing to fit Pre-Filter, Rhino tank,
and any optional add-ons
NOTE: DO NOT cut more pipe than necessary. You can cut more pipe later if
needed. If you're also installing a Pro-Install Kit or bypass loop, do so at this time.
Cut Pipes
Cut pipe along the marked sections from step
5 and clean ends of pipe. Ensure there are no
burrs, sharp edges or deep scratches.
6
NOTE: Cut tubing as straight as possible
with a utility knife, or an appropriate
pipe cutter for copper tubing or PVC.
CORRECT
INCORRECT