Signals
The end of filter service life signal
When 30 litres or 7 days of filter service life is left, A SINGLE beep will sound, and the
display will flash the values to indicate the need to replace the filter cartridge soon. The
sound signal will stop when the meter is turned on using the "
SET
" button or when water
begins to flow through the meter.
The end of service life signal
When the filter is used up completely (0 litres or 0 days), TWO beeps will sound to inform
you that the cartridge needs to be replaced. The sound signal will stop when the meter is
turned on using the "
SET
" button or when water begins to flow through the meter.
The flat battery signal
When the battery voltage drops below the normal level (the battery is flat), TWO beeps will
sound to inform you that the battery needs to be replaced. The sound signal will stop when
the meter is turned on using the "SET" button or when water begins to flow through the
meter.
PLEASE NOTE:
If the water fountain is not used for a day or more (e.g. if you are away or during a holiday
break), access to cold water should be blocked (the inlet tap should be turned off).
If the water fountain has not been used for more than a week, first let the water run for 5
minutes.
During transport, storage, and use of the water filter, the water fountain should be protected
against impacts or falls. Also, protect the device against freezing of the water inside. If the
water has a higher degree of hardness at 500 mg CaCO3/l, after softening it may have a
slightly salty taste. This is due to the exchange of calcium ions with sodium ions. However,
this is not a malfunction and is completely safe for your health.
If the ambient temperature during the water fountain operation reaches 38°С or more (more
than its maximum operating temperature), the device should be disconnected from the cold
water supply until the temperature drops.
