This wire when
coming from the tub
is 110 volts.
When it comes from
the steam generator
it is 220 volts.
This side is fed and
connected by your
electrician,
110 volts to power
the tub or 220 volts
when energizing
the steam
generator.
If you have purchased the optional tub water heater the following image and instructions are for you. If you
have not then please skip and disregard this section and you may pick up on the next page.
Pick a side wall water jet pipe that is convenient to work on. Measure the distance taken up by the water
heater. (Approximately 7 and 5/8 inches). Cut this part out. Glue the ends of the water heater and wait until
the glue sets as per the manufactures instructions. Plug the heater in. It has its own thermostatically
controlled on/off and temperature controls. It will turn on when there is water present and the temperature
is below 102degrees and will shut off at 104 degrees. Remember that this heater is plugged into a separate
GFI 110 volt circuit as discussed in two other sections of this manual.
