Drain the water tank
'$1*(5
1.
The water and power must be cut before you disassemble the E-Bidet
2.
Do not invert or tilt it before you finish draining the water tank
1.
Hold the plug with the tipper , turn to
"open" , and pull out . It will start to drain .
2.
After completing the drainage , insert
the plug and turn to "CLOSE" .
2QH212QH6HWWLQJ
● Install several electronic bidets in the same area, if you want each remote control to
control the specified electronic bidet, please complete setting as per following steps.
1. Open both cover and seat and without seating. Set the night light
to the "close" model (just see the "Light setting ").
2. Press the "stop" button and "adjust temperature" button on the
remote control at the same time, and keep pressing for a few seconds,
then hear the beep from the product and meanwhile the indicator
lights of "-,+" buttons are on.
3. Release the "stop" button, but keep pressing the "adjust temperature"
button
4. Press the "USER1" and "USER2" in order, and then release the "adjust
temperature" button. At this time, the lighted indicator is the current ID
code of product
5. By pressing "-, +" buttons to switch different product ID code with
corresponding indicator lights up. There are 10 ID codes in total.
It is on the first code by default and the light of "-" lights up
+
+
+
or
14
Summary of Contents for e
Page 1: ...Operating Instructions...
Page 5: ...Technical Drawing 4...
