7
6
FREEDOM PURE
®
www.aquama.com
www.aquama.com
2.1 Specifications
• Freedom
®
Pure unit (activation 1000ml / 1 litre).
• Base station.
• Transformer and Power Supply (Input 100~240V 50~60Hz, Output DC 9V 3A).
• A small white measuring spoon.
• A big blue spoon to mix.
• aquama
®
Spray Bottle.
• 100gr of natural salt for hydrolysis.
• A blue aquama
®
microfiber cloth.
2.2 Utilisation
• Disinfection – Eradicates approximately 99.99% of micro-organisms including
bacteria, bacilla, salmonella, pneumonia, legionnella, mildew, viruses, etc.
• Deodorization – will remove odors from hard surfaces and fabrics.
• Cleaning – All water-resistant surfaces such as:
plastics, glass, glass ceramic hobs.
• Stain removal – Cleans any type of fabric.
• Totally safe to use – non-toxic, 100% biodegradable, non-allergenic.
• The electric activation of the water and aquama
®
salt mixture
generates a sodium hypochlorite solution with an electrical charge
of between 600 and 1,100mV (improving its bactericidal and even
virucidal actions), depending on the desired degree of effectiveness.
• This device makes it possible to create your own detergent
and disinfectant solution with up to 240 ppm of (active)
sodium hypochlorite in 5 minutes.
• “LOW “ mode (an impulse) :
its activation time is three minutes.
Use low mode if you wish as a degreaser to clean
a surface with a lower level of disinfection.
• “HIGH” mode (two pulses) :
its activation time is five minutes.
Use high mode if you wish a better quality of
disinfection, always with a degreasing action.
IMPORTANT
A viricide can be made by following the
instructions available on the website
www.aquama.com
3.1 Caution: use only as directed
• Use only for hands, surface and fabric cleaning, disinfection and deodorization.
• Do not spray into your eyes. In case of contact with eyes, rinse immediately with plenty
of water and seek medical advice.
• Do not use this unit and activated solution near fire.
3.2 Directions for Safe Use
• Check that the inside of the base and the underside of the jug are completely dry before inserting the jug.
• Regularly descale the bottom of the jug.
• When not producing solution, never leave the jug, whether empty or full of solution, on the base.
• Remove the jug from the base for at least 5 minutes between each activation cycle, and disconnect
the socket from the base to enable the machine to cool more rapidly.
• Respect the recommended amount of salt (bactericide solution):
- 0.6L spray bottle 1x level white spoonful.
- 1L jug 2x level white spoonfuls.
• 2 to 3 cycles may be activated successively.
• For professional use: use on the day produced. Cannot be stored (standards not met).
• Reactivate the solution every 7 days (without adding salt).
• Do not fill the Freedom® Pure jug too high - Observe water volume marks.
• No need to add an excess of aquama
®
salt - The device will not start if there is excess.
• Use only the aquama® salt intended for this purpose in the suggested quantities.
• Do not move the unit during operation.
• Stock the solution safely (do not keep it in the refrigerator, since it could be confused with water).
• Unused solutions can be disposed in a sink. Unused solutions can also be reactivated,
restoring thedisinfection, cleaning and deodorizing power.
• Disconnect the electrical plug of the device after use.
• Do not leave the device in the sun.
• If the surface is excessively dirty or soiled, remove the excess dirt or soil first.
• Do not use ground water, polluted water or excessively hard water to fill the bottle or jug.
• Use water of temperature ranges from 5°C to 40°C.
A failure to observe the usage instructions can nullify the machine warranty.
SECTION 2.0 /
Parts supplied with the unit
SECTION 3.0 /
Safety instructions
WATER
SALT
ELECTRICITY
www.aquama.com
