Aquallice KRIBA, Quick Start Manual

Page: 13 / 16

PROBLEM CAUSE SOLUTION
The filter only provides a small
volume of the filtered water.
Vacuum heads have poor
suction.
• Valve handle is not correctly
placed in the FILTER position
• Filter is above the water
level and it is not correctly
primed
• Pool suction valves are
closed
• Suction lid or skimmer lid
are not removed
• Switch off the pump and
place the handle in the
correct position
• Place the filter in a correct
location and prime it.
• Open the pool suction valves
• Remove the skimmer or
suction lid
Intermittent functioning • Skimmer water level too low
• Filter is not correctly primed
• Fill up the pool with water
and prime the filter
• Proceed to prime the filter
Poor filter flow • Filter is dirty
• Filter is not correctly primed
• Perform BACKWASH
operation
• Prime the filter
Water appears in the filter
mouth
• Union between cover and
filter body is dirty
• Cover is not tightened
• Clean the remaining sand
from the filter mouth, place
the o/ring in the cover and
tightened the cover strongly
Filter valve drops by the waste
terminal
• o/ring damaged by incorrect
usage of the chemical
product
• Valve lid broken due to
wrong usage or excessively
tightening
• Change the upper valve lid
• Do not place chemical
product inside the skimmer
basket
• Change the vale lid, do not
tighten excessively.
TROUBLESHOOTING