Visage Digital exposed
installation instuctions
page 8
Locate a suitable entry point in the ceiling for the riser rail avoiding joists and
services.
8
The centre of the riser rail stands 45mm from the wall.
!
Drill a hole through the ceiling minimum Ø30mm, maximum Ø40mm.
9
Feed the riser rail containing the copper pipe
and data cable through the hole in the ceiling.
Ensuring that the control is at the desired
height, the rail is vertical and that there is
adequate working clearance above the top of
the rail in the roof space.
10
Drill and prepare the fixing points using the
fixings supplied, if suitable and fix the unit
to the wall using the screws provided.
11
The ceiling plate cannot be sited against an
uneven surface. If there is coving or an
alternative obstruction, please ensure the entry
hole is neat and unobtrusive; otherwise the
copper tube could be visible within the
showering area.
!
Place the rail bracket support pillar into the
desired location ensuring that both the hose
restraint and handset holder are below the rail
wall bracket.
12
If the ceiling height is over 2.4m (8ft), a Digital riser rail extension kit will be
required. Contact our Customer Service Department to purchase a riser rail
extension kit (part no. 223217).
Slide the fixing bracket over the rail and
support pillar and mark the fixing points.
Remove the fixing bracket and drill and prepare
the fixing points using the fixings provided, if
suitable. Secure the bracket to the wall using
the screws provided.
13
