ilux Digital Bath control
– pre-set operation
5. Press and hold the desired pre-set button for 3 seconds.
The selected pre-set button will continue to flash to indicate
the controller is in pre-set recording mode. The temperature
and flow control functions will be disabled whilst the bath
controller is in pre-set mode.
6. When the bath water is at the desired depth, press the Start/Stop
button to complete the recording of bath fill depth and temperature.
Differing user body mass will affect the overall depth of the bath.
Care should be taken to ensure the bath does not overflow.
7. Repeat the above procedure to store the remaining pre-set buttons.
8. Once set, the bath pre-set buttons may be erased and re-recorded by following the
procedure above as required.
To operate the bath using the pre-set buttons
9. Put the plug in and press the desired pre-set button. The bath will start at the pre-defined
temperature and flow rate.
Consideration should be given to the length of time the plumbing system requires
to reach the desired bath temperature and factored into the bath pre-set.
The temperature and flow rate settings can be overridden when the
bath is operating in pre-set mode.
To prevent accidental overfilling, once a bath has been filled
using the pre-set function, the controller pre-set buttons will be
disabled for 1 minute. The controls will still operate manually
if required.
The bath fill can be operated manually or via the memory pre-set buttons.
Due to performance characteristics of combination boilers, inlet temperature change
may cause the following symptoms to be experienced during bath operation:
The temperature LEDs may flash; this is not necessarily changing the outlet
temperature.
10.
11.
11
ilux LAVINGTON User revisedv2.qxd:Layout 1 21/11/12 11:52 Page 11
