Shower Panel SL650 Installation Guide
Refer to the technical diagram to choose the proper location for your shower panel, you can adjust
the column’s vertical position based on the person’s height.
Flat wall Installation
.
1.
Choose the proper location for your shower column. Mark the drill holes Ø7mm. Two holes
above and two holes down below. Horizontal distance between two holes drilled side by side is
30mm apart from the center of each hole. The two hole groups are 700mm in vertical distance
from each other. Then insert wall anchors (2) in pre-drilled holes (1).
2.
Clean the wall around the holes (1) thoroughly with a dry cloth. Pell paper backing of the factory
pre-installed double-side tapes (26) on the mounting brackets (3). Place the mounting brackets (3)
and make sure the small holes on them are just at the wall anchors (2), and then adhere upright to
the wall.
3.
Secure the mounting brackets (3) to wall with long screws (7) and stainless steel washers (6).
4.
Connect the elbow (8) to the connection (23) of pipe, and fix them with screws (22). Screw the
overhead shower (12) to the elbow (8) placing the rubber washer (11).
5.
Hold up shower column (9), and insert the fixing brackets (10) to the mounting brackets (3). Use
the small tool (5) to tighten screws (4) into both sides of the mounting brackets (3), and then put
the adoring covers (25).
6.
Push the soap shelf (15) to the support (14) on the column.
7.
Place rubber washers (16)(18) into each nut of the long shower hose (17), and secure one nut to
the right bottom of shower column, and the other nut to the hand shower (13). Plug the hand
shower (13) onto the holder of soap shelf (15).
8.
Place a rubber washer (19) into one nut of the short hose (20), and secure it to the bottom of
shower column (9). Place a mesh gasket (21) to the other nut of the short hose (20), and secure it
to the existing faucet (24).
NOTE:
①
Do not forget to use the rubber washers to prevent leakage on the connection.
②
If you find that pressure or water volume is unusual, please clean the mesh gaskets
(21) regular.
Summary of Contents for SL650
Page 1: ......