Problem
Low flow from pump
1. Clean the pump cage and impeller.
2. Ensure pipework is not blocked.
3. Ensure the pump power is set to the correct desired level.
4. Reset power to pump.
No flow from pump
1. Check the plug from the pump is connected correctly to the controller.
2. Check power supply is on.
3. Check fuse and wiring (see electrical installation)
4. Follow Low flow procedure above.
Controller stuck on warning message
If the controller is stuck on low water or jammed message, after the problem has been rectified,
reset the power to the controller. If this has no affect, contact Interpet (Blagdon) Consumer Advice
Department.
Maximising performance
1. Keep the height to which the water is being pumped (head) to a minimum. The higher the head
height the lower the flow rate.
2. Use the largest diameter, smoothest bore pond hose over the shortest distance, and keep hose
fittings to a minimum. This removes frictional loss of flow and so increases pump flow rates.
TROUBLESHOOTING
12
EN
