11
Mot
or's po
wer cord
Water line
Wire tie
Wire tie
Liquid-tight
connect
or
Connect to a
Control Panel
(See instructions included
separately with each control)
or
Connect to a
garden hose fitting
(Available separately
Part #W-1)
WARNING
Fig. 10
Water Connections
Insert the water line tubing into the brass connector at the front base of the housing. Insert the other
end of the tubing into the brass connector at the upper left side of the flowmeter panel.
Tighten only
about 1/2 turn past finger tight.
Using the wire ties provided, secure the water line tubing to the motor
power cord. (Refer to
Fig. 10
)
The flowmeter panel is equipped with a 1/4"
FNPT thread at the base of the inline strainer
and can be connected to a water supply in
various ways. (See
Fig. 10
)
•The Flowmeter Panel can be connected
directly to an automated timer, thermostat
or humidistat control.
•For a garden hose connection, a female
swivel water hose connector assembly is
sold separately (Part #W-1).
•The flowmeter panel can also be
connected directly to a water supply
using 1/4" NPT fitting.
Attach the 1/2" drain tubing (push fit) to the
drain fitting (Part# 8) at bottom of housing.
Connect motor's power cord using the liquid-
tight connector provided. (See
Fig. 10
)
For information on wire guage. (See
Fig. 11
)
•If automating the Turbo XE using
a control system, relays or electrical
contactors may be required along with
water solenoids to control water supply.
•For manual operation, connect the
motor's power line to an optional
watertight electrical plug (Part #P-1).
C
ONNECTING
U
TILITIES
Power Connection
ALL WIRING AND ELECTRICAL
CONNECTIONS MUST BE PERFORMED
BY A QUALIFIED ELECTRICIAN. INSTALLATION MUST BE
IN ACCORDANCE WITH LOCAL AND NATIONAL CODES.
WARNING
Wire to a
Control Panel
(See instructions included
separately with each control)
or
Wire to an
electrical plug
(Available separately
Part #P-1)
or
Wire directly to an
On/Off switch
Flowmeter
Panel
Flow
Control
Inline
Strainer
Drainage
Line
Direct to a
containment or
drainage area
