under supervision or following an instruction on the safe operation of the device to ensure that
the person is aware of any associated risks. The device is not a child's toy! Do not let children
to clean or perform maintenance on the device without supervision.
ASSEMBLY AND START-UP
PREPARATION
The GLOSSY MARINE aquarium set is delivered to the customer packaged in a cardboard box
placed on a wooden Euro-pallet. After the set has been delivered to the room where it will be
installed:
1. Carefully remove the outer cardboard box and the protective film.
2. Take the box off the Euro-pallet. Since both the tank with the lid and the cabinet with its
contents are quite heavy, at least two strong men are required for this task. Take the aquarium
tank off the cabinet. Next, take the cabinet off the Euro-pallet and place it in the desired location.
Do not move it too close to the wall, since you will require free access to the rear part of the
tank until the plumbing components have been installed.
3. Place the aquarium on top of the cabinet.
4. Carefully remove the protective foil and padding off the sump. Inside the sump, you will find
a protective mat stored there during transport. Put the protective mat under the sump. Place the
sump on the left side of the aquarium cabinet (as viewed from the front of the tank), as close to
its left wall as possible. A small shelf is pasted in the upper part of the rear wall of the sump. In
the shelf, there are two apertures for the plumbing of the main and emergency drains.
5. Proceed to the installation of the plumbing components. For this purpose, stand behind the
aquarium and take the lid off the overflow box.
The set includes three plumbing units. They are the feeding, draining, and emergency draining
units.
The feeding unit consists of a piping union that is passed through the aperture in the upper part
of the rear wall of the aquarium tank (on the right side of a person standing behind the aquarium)
and a flexible LOCK-LINE directional nozzle. In order to screw the piping union into place,
unscrew the nut and pass the piping union through the aperture in the rear wall of the tank so
that the black gasket touches the wall from the inside of the tank. Next, screw the piping union
into place.
Finally, screw the LOCK-LINE directional nozzle into the piping union from the inside of the
aquarium tank. Note! You are not recommended to disassemble the nozzle for the purpose of
installation, since its reassembly would require the application of considerable force, which –
