10mm
Door panel
Fixed panel
Step 6.1
Ensure the glass clamp is in about 10mm away from the fixed panel edge(Diagram 6.1) then attach it onto the
fixed panel using M10 x6 grub screw(Part 20)
Step 6.2
Fit the support arm wall fixing onto the support arm bar and place it onto the wall in required position.Measure
the dimension from the glass clamp to the wall fixing to get dimension Y.Cut the support arm to the required length
X according to the formula X=(L-Y)+25mm(L is the original length of the support arm bar,1057mm)
Step 6.3
Fit the support arm wall fixing onto the support arm bar before inserting the support arm bar onto the glass clamp,
move the wall fixing to the wall and level the support arm bar, mark the postion of the wall fixing onto the wall.Drill
through the marked position on the wall using a 6mm masonry drill bit and insert the wall plug(part 8).Fix the
wall fixing onto the wall using screw ST 4X30(Diagram 6.3).
Insert the T-piece (part 27) onto the support arm bar then insert the support arm bar to the wall fixing,pull the bar
out from the wall fixing to insert into the glass clamp, then secure the support arm bar together with the glass
clamp and wall fixing using M5x6 grub screws.
T-piece connector for side panel support bar
6.1
6.2
6.3
Step 7.1
Measure the support bar tube length then
cut it to the required size,fit the Glass
Clamp(Part 29) onto the side panel then
secure it onto the side panel using a M10
grub screw(Diagram 7.1)
Step 7.2
Fit the support bar tube onto the Glass clamp
and T piece(part 27) then secure them to
each other using M5 grub screws(Diagram 7.2)
Step 7.3
Stick the Bubble Seal (Part 37) onto the door
panel(Diagram 7.3)
7.1
7.2
7.3
22
