Step 2.2
Press the bottom strip end cap R(part 10) onto the closing profile (part 29),then sit the closing wall profile
onto the bottom rail against the holes drilled on the wall.Secure the closing wall profile onto the wall using
ST 4x30 screws x4(Part 9).
2.1
Step 2.1
Insert the bottom rail into the end cap L(Part 10) fitted on the fixed panel wall profile
(Diagram 2.1)
Inside
2.2
Level
Straight
2.4B
2.5
INSIDE
2.6A
2.6B
2.4A
Step 2.4
Remove the fixed panel then replace the bottom strip (Part 11) onto the tray, ensure the bottom strip groove is
level to the wall profile groove on the inside face (Diagram 2.4A). Mark the line on the tray for the bottom strip
position once you have ensured it is straight. (Diagram 2.4B)
Step 2.5
Drop the silicone sealant onto the bottom side of the bottom strip,take the 3M adhesive tape back away then
carefully place it onto the tray against the marked line.(Diagram 2.5)
Step 2.6
Drop the silicone sealant into the groove of the bottom strip(Diagram 2.6A) then carefully lift the fixed panel
and insert it into the bottom strip then push it onto the fixed panel wall profile.After the fixed panel has been
placed at the required position insert the fixing seal from top to bottom to secure the fixed panel onto the
wall profile (Diagram 2.6B).
2.3
0-20mm adjustment
Outside
Step 2.3
Carefully lift the fixed panel (Part 3) and insert into the wall Profile groove,it allows 0-20mm for the adjustment.
Once the fixed panel is in required adjustment, place the bottom strip(Part 11) onto the tray and mark a line
onto the profile. Cut the profile through the marked line to get required length.(Diagram 2.3)
2.3
INSIDE
12
