28
10 Taking a reading
Please note: All probes are shipped with the battery pack disconnected. To
activate the probe, the probe head needs to be removed by turning it through 45
0
first and then by pulling it upwards. Make sure the battery board is properly seated
and then connect the battery pack. The date/time needs to be set before a reading
can be taken. In the absence of the RF Utility Toolkit, the date/time can also be set
with logger using the profile log option. In this case the logger memory has to
cleared immediately after the download to prevent obsolete data to be imported into
the database. Browse the logger menu to the CLEAR ALL LOGS menu option and
press the enter button.
To take a normal reading from a probe, the probe first needs to be added to the
profile list of logger.
10.1 Adding a probe as a profile
How to:
Go to
Profile Setup
by scrolling down the menu by pressing the menu
button option on the keypad of the logger several times until you reach
Profile Setup
,
Press Enter
Insert profile #, i.e. 001 by using the numbers on the keypad;
Press Enter
Add probe ID to this profile, i.e. 5177 by using the numbers on the keypad.
Press Enter. Profile 001 has now been populated with probe ID 5177.
Exit
10.2 Download readings
10.2.1 Profile Log
To download the most recent readings (from the previous download) of a specific
probe:
How to:
Switch the logger on by pressing and holding the Enter button for a ½
second.
Press menu and scroll to Profile Log