product settings and troubleshooting
Your cleaner moves about your pool by way of 1 adjustable pin located on
each end of the axle on the bottom side of the cleaner. There are various
positions that the pins can be set. Each setting will affect how wide or tight
the cleaner turns when running in it’s cleaning cycle.
It is recommended that before every cleaning cycle you switch the pin position
(on the same sides) so that the axle is cleaning the opposite way. This is so
that your cleaner can reach all areas of the pool and prevents the cable from
tangling.
Make sure the axles are freely moving and the axle channels are clear.
There are 2 possible configurations that the axle can be locked into. With the
cleaner flipped over and movable axle furthest away, the axle must always be
set in front of the pin. See the diagram below.
The E-Z Swivel is a feature that will help untangle the floating cable should
this occur. To use the E-Z Swivel it is recommended that you stand outside
of the pool.
Make sure that the floating cable is disconnected from the power supply!
Now grab the large part of the grip on the floating cable. Using one hand,
pull towards the direction that is between you and the power supply and walk
away from the cleaner. As you move further from the cleaner, the floating
cable will untangle itself and straighten out.
NOTE: It is recommended that you turn OFF the power supply before
entering the pool with the cleaner in the water.
Direction of
Power Supply
Direction of
Cleaner
Axle
Position
Axle
Position
Axle
Position
Axle
Position
Fixed Pin
Adjustable Pin
product settings
AXle And turning pins
hoW to use the e-Z sWiVel to help untAngle
FloAting cAble
Using E-Z Swivel while cleaner
is OFF and still
inside
pool
Using E-Z Swivel while cleaner is
OFF and
outside
pool