Working with the Outlet
Note: The pool cleaner is not part of the pool. Please contact your seller.
The cleaner is designed to remove impurities settled on the bottom with the help of
the filter. With the help of a hose and the outlet head, the pump propels the water
stream into the filter, where impurities are caught.
a. Remove the skimmer locking top. Switch the filtration unit valve to the position for
filtration and turn on the filtration unit.
b. Fill the outlet hose with water (e.g. with a water stream from the return fitting).
c. Hold the free hose end under the water level and connect the plate to it. Wait until
the water stream starts flowing from the plate and then insert the plate quickly
into the skimmer housing and install it firmly above the skimmer basket. While
installing the plate into the skimmer, do not interrupt the water flow in the hose
and ensure that the first end of the hose is immersed in water all the time.
Note:
If you want to use the outlet adapter, proceed as follows:
1. Remove the skimmer locking top and remove the overflow system flap valve (carefully in order to avoid damaging the flap valve).
Insert the plate with the adapter installed (the adapter hole must remain submersed below the water level so that the filter can
draw water) and direct the adapter towards the pool. Switch on the filter unit.
2. Fill the outlet hose with water (e.g. with a water stream from the return fitting), and install the other end on the adapter inside the
skimmer. While doing so, be sure that both ends remain below the water level.
d. Connect the pool outlet onto the opposite end of the hose (which must be below the water level all the time).
e. Now you can start using the outlet. While using it, make sure the outlet head does not get above the water level and that the suction
system does not get aerated. Draw impurities from the bottom slowly, as any sharp movement of the outlet will cause any settled
impurities to blow around.
f. Once the suction phase is complete, please disconnect the hose from the plate and remove the plate from the skimmer housing.
At the end of the suction phase we recommend checking the filter to see whether it requires cleaning.
Pool Cleaning
During the season various impurities will settle on the wall of the pool, ie: skin fat, cosmetics and sunbathing creams, sweat, dust, insects,
leaves, seeds, grass straws, impurities from air and pool surroundings, as well as water hardness settled down. These impurities form a
suitable environment for algae and bacteria formation. It is therefore recommended that the pool liner be cleaning thoroughly once a year,
preferably in spring before filling with water.
Round Satinwood Pool
21
