Aqua Systems Eradicator Gen II, Owner'S Manual

Page: 8 / 12

© 2019 New Aqua LLC dba Aqua Systems • 114 Vista Park Way • Avon IN 46123
8
Eradicator Gen II O
3
Owners Manual Supplement
Ozone Specific Information
Installation
On the circuit board, unplug the power plug (4-wire), and the
meter plug (3-wire) on the lower right side of the board, then
the motor plug on the lower left side of the board. Carefully lift
up slightly the tab holding the circuit board in place, then gently
pull the board forward, then lift the board out.
Next, remove the drive bracket by gently lifting the two tabs
securing the the bracket and tilt it forward from the tabs. The
lower edge of the drive bracket has two notches that rest on
the drive back plate. Lift up and outward on the drive bracket
to disengage the notches.
Then, remove the power supply wire and transformer by
pushing/pulling it through the slot in the backplate.
Set the power supply and cord aside as it will not be
used in this application.
Gen II O
3
with Ozone
EOG II Wire Harness Assembly
Circuit board
locking tab
Drive bracket
locking tabs
Drive bracket
notches
Motor
Plug Power
Plug
Meter
Plug
1.
2.
3.