OPERATING INSTRUCTIONS
To operate your spa you use your main control panel (keypad).
– it features 4
buttons (Pump, Blower, Light, Up/Down) and an LCD screen, which displays
information on the status of the system, such as the water temperature or error
messages.
Keypad TSC9
Key to Display Panel Icons and Buttons
Button /icon
Blinking
On
Pump active
Blower active
display shows desired
temperature
Heater not active, but water is
heated to desired temperature.
Heater active
Light on (high intensity)
Filter function suspended
Filter function active
Aqua Spa Owner´s Manual, page 11
MAIN FUNCTIONS
This section describes the most commonly used functions during the operation of the
controller.
Typically, each function is managed by a specific button, however sometimes the same
button can be used to control more than one function (depending on the version of the
firmware installed).
The table below summarises the functions assigned to each button.
Button
Function
Pump
Starts and stops jet pump.
Blower
Starts and stops the blower.
Light
Switches the light on and off
Up
Increase the values being set.
Down
Decrease the values being set.
Pump
if the pump is not stopped manually, it stops automatically after 20 minutes of
continuous operation.
Light
if the light is not switched off manually, it switches off automatically after 20
minutes.
Blower
if the blower is not stopped manually, it stops automatically after 20 minutes of
continuous operation.
Filtration
– during operation, the filter icon is on steady; if one of the buttons, pump,
blower or light is pressed during a purge cycle, the cycle is interrupted and will only
resume 40 minutes after the last device stops.
Filtering function.
When the filtration cycle is active, the filter icon will light up
continuosly. The spa is programmed to run a filtration cycle once a day for 6 hours.
During the filtration cycle the pump and blower run in high speed mode for one minute
to purge the plumbing, followed by the pump at low speed for the rest of the cycle. It is
possible to program the duration of the filtration cycle. Hold the “light” button for 5
seconds, the display shows the current duration value. Use the “Up/Down” key to adjust
this value. Press again the “Light” key, the display shows the parameter D indicates the
number of hours to delay the start of the filtration cycle, use the “ Up/Down” key to
adjust the value.
During the set up, if the user doesn’t press any key for 5 seconds, the system memorises
the new setting, but it will take effect only at the next cycle. However, if the user exits the
setting by pressing the “light” key again the new setting is memorised.
If during the filter cycle the user presses any key, the cycle is suspended whilst the spa is
being used. Once the spa has been inactive for 40 minutes the filtration cycle continues.
When the Filtration cycle is suspended the filter icon LED will flash intermittently.
Aqua Spa Owner´s Manual, page12
