background image

AP9100

+

 Water Filter System

Installation and operating instructions

Not even an Aqua-Pure

®

 fi lter can make unsafe water safe

The  water fi lter system should only be used on water that is 
microbiologically safe – that is, water that has been adequately chlorinated 
or disinfected. Additional equipment (such as a chlorine injection system or 
an ultraviolet steriliser) will be required for unsafe water.

It works best when it’s used

If the Aqua-Pure

®

 water fi lter system has not been used for more than one 

day, you will need to fl ush 1 to 2 litres of water through the system before 
using the water. The  requires a minimum water supply pressure 
of 172 kPa (25 psi) and not exceed a maximum water pressure of 862 kPa 
(125 psi). A 650 kPa (94 psi) pressure limiting valve must be installed on 
the inlet side of this system (see below).

What a valve

The  water fi lter system has been supplied with an Aqua-Pure

®

 

650 kPa Multi-Function Control Valve (MFCV) as standard equipment. 
This valve must be installed as detailed in the installation drawings and 
instructions, to provide:

• Flow restriction 

• 650 kPa pressure limiting

• Dual check backfl ow prevention 

• Anti-hammer protection to the fi lter system

This valve is fi tted with a Particle Removal Screen on the inlet side to protect 
the intricate mechanism from debris that may be in the water supply. This 
screen must remain in place at all times. Failure to comply with these 
requirements will void the warranty.

Have a change of heart every 12 months

The heart of an  fi lter system is the AP9950 fi lter cartridge, which 
has a recommended maximum life of 12 months. The life and performance 
of a cartridge may vary depending on the volume and quality of the incoming 
water supply being fi ltered. Your cartridge may need replacing earlier than 
12 months if you notice a reduced fl ow from the mixer tap, or the return of 
an unpleasant taste/odour to the fi ltered water.

Worth doing…worth doing properly

Installation of the  fi lter system must comply with any existing 
state or local plumbing codes, some of which require installation by a 
licensed plumber. For correct operation of this appliance, it is essential that 
these installation and operating instructions be strictly observed.

WARNING:

 For correct operation of this appliance, it is essential that these 

installation and operating instructions be strictly observed.

CAUTION:

 

Do not use with water that is microbiologically unsafe or with 

water of unknown quality without adequate disinfection before or after the 
system. Systems certifi ed for cyst reduction may be used on disinfected 
water that may contain fi lterable cysts.

 REF 

DESCRIPTION 

QTY 

PART NO

  1 

3M VH3 3/8” NPTF Filter Head 

70020021120

  2 

AP9950 Replacement Cartridge 

AK200125909

  3 

98210 MFCV 650 kPa 

AK200094782

  4 

1/2” BSP X 1/4” BSP Brass Nipple 

AK200093396

  5 

Braided Hose 10mm 

AK200095474 

 

 

1/2”BSPF x 1/2”BSPF 1.0m

  6 

1/2”BSPM -1/2”BSPF Brass Elbow 

AK200094428

  7 

3/8” NPT - 1/2” NPT Brass Nipple 

AK200119308

  8 

1/2” BSP Brass Nipple 

AK200093404

  9 

NEP A3 Bypass Plug 

70020160308

 10 

Thread 

Tape 

AK200095102

1

7

9

8

10

2

4

5

3

6

PREPARATION

1.   Check your  Aqua-Pure  component identifi cation and content checklist:

Connect to cold water line 
of existing mixer tap

WATER FILTERS

Reviews: