Slot
3 Required Tools
For installation, you need the following tools and materials
：
•
Metal wrench 13mm / 14mm / 17mm
•
Scissors
•
Power Drill
•
Drill Bits 6mm / 12mm
•
PTFE
Tape
Caution
This system is equipped with quick fitting connect
ors
. With the quick fitting connect
ors
, you can easily and safely
connect the PE tubes. Plug the tubes into the counterparts until you feel a click.
When
click occurs
, then
the tube is
correctly fastened in the anchoring device.
If you want to remove the tube again, you must, at first, remove the
retaining clip.
And then, at the junction, you will see a small white plastic ring. Press the plastic
ring evenly then pull out the tube.
If the
mains
water pressure is higher than 6 bars, one pressure- reduc
ing
device must be installed before the inlet port of
the Pura
.
4 RO
Installation
1
Open the lid of
the Pura housing.
Remove the combo cartridge filter from the
Pura
.
The combo cartridge filter has been loaded into the
Pura
for transportation
.
2
There are two small black rubber seals
on one side of the membrane
.
3
In the center of the
Pura
, you can see a
circular slot
for the membrane.
4
Insert the side which has the two small black rubber
seals into the circular slot.
Open the lid
Illustration without
housing
for better
understanding
AquaPerfecta.com
0800 007 3737
Two small black
rubber seals
