*
The applied power source must be the 12V DC power source (as Figure 3).
*
Do not block the inflation inlet
①
, and ensure that the inflation inlet
①
shall
remain smooth at all times.
*
Observe the local waste treatment provisions, and it is not allowed to throw
the air pump away randomly.
*
Don't use this product when the hose is damaged.
*
Don't pull out the hose when inflating, because
the high pressure may hurt you.
*
Don't keep the air pump working for more than 15
minutes, because motor overheating may
cause internal damage. The air pump shall
be fully cooled for 30 minutes after continuously
working up to 15 minutes.
* Notice: The factory default setting air pressure is 10PSI (10PSI=0.689BAR).
From the second-time use, the default air pressure will be the value you set
in last time.
* Notice: When the air pump is powered on and without any operation over 2
minutes, it will enter standby mode. You can press the On/Off button
to re-activate the pump.
* Don't use this air pump if any part is damaged. Please contact local dealer
for after-sales service.
* This product shall not be exposed to the rain or immersed in water.
* The inflation inlet should not point to the face or body while working.
* Do not leave the air pump unattended while inflating.
* Do not turn off the car engine when the product is in use to avoid
unnecessary damage.
6
V.
Precautions
EP-T16
（F
igure 3
）
