* Connect the end with flexible conduit adaptor
⑩
of the hose to the air pump
inflation inlet
①
, and twist clockwise to tighten it as Figure 1.
* Install the other end of the hose into the supporting air tap of the air
bag (step 1 in Figure 2).
* Plug the DC plug into the 12V DC socket.
* Press the toggle button to switch the unit of air pressure.
* Press the UP button or DOWN button to set the pressure value
you need, with the range of the pressure value from 0 to 16PSI,
(1PSI=0.0689BAR)
* After finishing the above steps, press the On/Off button to start
inflation.
* During the inflation process, you can press the UP button or DOWN
button to increase or decrease the targeted air pressure, press the
toggle button to switch the unit of air pressure, and press the On/Off
button to stop.
* When the air pressure reaches the set value, the air pump will stop
automatically.
* When the inflation is completed, unplug the power cord.
* When not in use, remove the inflation hose from the air pump and store it
properly.
5
IV. Inflation Operation
EP-T16
（Fi
gure 1
）
（Fi
gure 2
）
