25
TABLE 4: TORQUE SPECIFICATIONS
PART #
DESCRIPTION / KEY ITEM #
TORQUE
103549
HP Module Body (13)
25 ft lb (33.9 Nm)
108305
Swivel Port Plug (41)
60 in lb (6.8 Nm)
054300 / 054232
Safety Plug Assy (35)
90 in lb (10.2 Nm)
108308
Fill Port (32)
90 in lb (10.2 Nm)
103530 / 102810
Dial Indicator Gauge (14)
45 in lb (5 Nm)
108318
Bonnet (23)
90 in lb (10.2 Nm)
AP5752
Diaphragm Clamp (3)
15 ft lb (20 Nm)
TABLE 5: TEST BENCH SPECIFICATIONS
TABLE 6: RECOMMENDED CLEANERS AND LUBRICANTS
LUBRICANT/CLEANER
APPLICATION
SOURCE
Christo-Lube MCG 111
All o-rings
Aqua Lung, (PN 820466) or
Lubrication Technologies
310 Morton Street
Jackson, OH 45640
(800) 477-8704
Oakite #31
Acid bath for reusable stainless steel and
brass parts.
Oakite Products, Inc.
50 Valley Road
Berkeley Heights, NJ 07922
White distilled vinegar
Acid bath for reusable stainless steel
and brass parts.
“Household” grade
Liquid dish washing detergent
(diluted with warm water)
Degreaser for brass and stainless steel
parts; general cleaning solution for plastic
and rubber
“Household” grade
CAUTION:
Silicone rubber requires no lubrication or preservative treatment. DO
NOT apply grease or spray to silicone rubber parts. Doing so may cause a chemical
breakdown and premature deterioration of the material.
CAUTION:
Do not use muriatic acid for the cleaning of any parts. Even if strongly
diluted, muriatic acid can harm chrome plating and may leave a residue that is
harmful to o-ring seals and other parts.
TEST
CONDITION
SPECIFICATION
Leak Test
Inlet 3000 PSI (207 BAR)
No leaks allowed
MP
Inlet 3000 PSI (207 BAR)
145 ±5 PSI (10 ± 0.34 BAR)
MP Creep
Inlet 3000 PSI (207 BAR)
5 psi (0.34 BAR) max between 5 to 15
seconds after cycling regulator (purge)
Opening Effort
Inlet 3000 PSI (207 BAR)
+2.5 to +3.5 inch H
2
0 (6.2 -8.7 mbar)
Flow Effort
MP 145 ±5 PSI (10± 0.34 BAR)
+5 inches H
2
0 (12.5 mbar) (maximum) at
8 SCFM (227 LPM)
Purge Flow
MP 145 ±5 PSI (10± 0.34 BAR)
5 SCFM (142 LPM) flow rate (minimum)
