Copyright © 2020 Aqua Creek Products All Rights Reserved
Revised 6/25/20
Revolution Spa Assembly Instructions
STEP 2: INSTALL LIFTING ARM
Locate the LIFTING ARM and the following hardware:
• (1) 1/2” x 2-3/4” SHOULDER BOLT
• (1) 3/8” x 2” SHOULDER BOLT
• (1) 5/16” FLAT WASHER
• (1) 5/16” NYLOCK NUT
• (1) 3/8” FLAT WASHER
• (1) 3/8” NYLOCK NUT
Remove the shipping strap and all packing from
the LINEAR ACTUATOR. Connect the LIFTING ARM
between the MAST and the LINEAR ACTUATOR as
shown in the fi gure below. Make sure the end marked
“B” attaches to the mast. Tighten NYLOCK NUTS (2)
until snug as shown in PHOTO 2.
DO NOT OVERTIGHTEN!
STEP 3: INSTALL CONTROL ARM
Locate the CONTROL ARM and the following
hardware:
• (1) 1/2” x 2-3/4” SHOULDER BOLT
• (1) 3/8” FLAT WASHER
• (1) 3/8” NYLOCK NUT
Install the CONTROL ARM (end marked “A”) onto
the MAST as shown in the fi gure below. Tighten the
NYLOCK NUT until snug as shown in PHOTO 3. DO
NOT OVERTIGHTEN!
STEP 2
STEP 3
1/2" X 2 3/4"
SHOULDER BOLT
3/8" FLAT
WASHER
3/8" NYLOCK
NUT
3/8" X 2"
SHOULDER
BOLT
5/16" FLAT WASHER
5/16" NYLOCK NUT
LIFTING
ARM
ACTUATOR
3/8" NYLOCK NUT
3/8" FLAT WASHER
1/2" X 2 3/4"
SHOULDER BOLT
CONTROL
ARM
7
