Copyright © 2019 Aqua Creek Products All Rights Reserved
Revised 8/22/19
Two Piece Control Box Installation
HOSE CLAMP (2)
Connect the two (2) hose clamps to the actuator shaft. To
do this, use a fl at blade screwdriver to open the hose clamps.
Put the opened hose clamp around the actuator shaft and
close the clamp. Secure the clamp using the fl at blade
screwdriver but leave loose. See fi gure to the right.
With the Linak two
piece control box
installed, slide the
bracket over and down
onto the two hose
clamps. Be sure to use
the top and bottom
tabs of the bracket,
not
the middle tab.
See fi gure to the left.
Using the fl at blade
screwdriver, tighten
the bolts on the hose
clamps to secure control
box in place.
See fi gure to the right.
CONNECT TABS
TO HOSE CLAMPS
TIGHTEN BOLT
TIGHTEN BOLT
TOOLS REQUIRED:
FLAT BLADE SCREWDRIVER
4
