cuplex kryos NEXT VARIO 04/2017
cuplex kryos NEXT
cuplex kryos NEXT
cuplex kryos NEXT
cuplex kryos NEXT
Operating and assembly manual
Operating and assembly manual
Operating and assembly manual
Operating and assembly manual
1. Preparation
1. Preparation
1. Preparation
1. Preparation
Back up your data before modifying your hardware! Disconnect your PC from
the mains power outlet. To prevent damaging the sensitive hardware compo-
nents, make sure to ground your workplace and yourself to prevent electrostat-
ic discharges.
When upgrading an existing PC setup, remove the installed heat sink from the
CPU. Refer to the instruction manual of the CPU cooler for details. Remove
thermal grease residues from the CPU surface using benzine if necessary.
Place a small drop (diameter ca. 4 mm or 0.15 inch) of thermal grease sup-
plied with the cuplex kryos NEXT centrally on the CPU. Alternatively, you can
apply a thin layer of the thermal grease using the supplied plastic spatula.
2.1. Instructions for Socket 2011-3, 2011, AM4
2.1. Instructions for Socket 2011-3, 2011, AM4
2.1. Instructions for Socket 2011-3, 2011, AM4
2.1. Instructions for Socket 2011-3, 2011, AM4
Place the cuplex kryos NEXT on top of
the thermal grease covered CPU, ob-
serving the orientation as shown in the
picture. Place on spring into each re-
cess and insert a knurled screw
through each spring into the anchor
threads of the CPU socket (only one or
two revolutions). Alternately fasten
each screw a fraction of a revolution
until all four screws are fully fastened.
© 2016-2017
Aqua Computer GmbH & Co. KG – Gelliehäuser Str. 1 – D-37130 Gleichen
computer
aqua
