IMPORTANT FOR FUTURE REFERENCE
Please complete this information and retain this manual for the life of the equipment. For
Warranty Service and/or Parts, this information is required.
Model Number
Serial Number
Date Purchased
2
SAFETY PRECAUTIONS
GENERAL INFORMATION
INSTALLATION
APW Wyott equipment is designed, built and sold for commercial use and should be operated by trained
personal only. Make sure all CAUTIONS, WARNINGS and operating instructions are clearly posted near
each unit to insure proper operation and reduce the chance of personal injury and/or equipment damage.
Always disconnect power before cleaning or servicing the unit. Surfaces will remain hot after power has
been removed, allow unit to cool before cleaning or servicing. Never clean the unit by immersing it in water.
The unit is not protected against water jets; DO NOT CLEAN UNIT WITH A WATER JET. Always clean
equipment before first use.
Check the rating label for your model designation and electrical rating. Rating Label is located on the inside
frame of the unit.
18.25 (46.4 cm) W x 18.5 (47.0 cm) D x 25.12 (63.8 cm) H
120VAC, 660W, 60Hz, NEMA5-15 Plug
6 foot, 3 wire grounded cord. If the supply cord is damaged, the manufacturer or an authorized service
agent or a similarly qualified person must replace it in order to avoid a hazard.
54 Lbs. (24.5 Kg.)
1.
Unpack Unit
Remove unit from shipping carton, unwrap loose parts and remove any packing tape, plastic wrap
and nylon tie-down.
Prior to initial start-up, all removable parts and interior surfaces should be cleaned with
warm soapy water to remove manufacturing oils, then rinsed and dried thoroughly. Please follow
the cleaning instructions on page 3.
2.
Switch the position of the door knobs from inside to outside by using a screw driver. The knobs are
on the inside for shipping purposes.
Overall dimensions:
Electrical ratings:
Power Cord:
Shipping Weight:
NOTE:
