APURO CD400-A, Instruction Manual

Page: 3 / 8

2
Telephone Helpline : 1 888 747 1447
Assembly
1.
Insert the mincing barrel into the motor housing mouth, with the hole facing upwards [Fig. 1] .
2.
Tighten the locking knob [Fig. 2] .
3.
Insert the feed screw in to the mincing barrel. Turn the screw slightly to slot the base of the screw on
to the transmission shaft, if necessary
[Fig. 3] .
4.
Insert the cutting blade on to the end of the feed screw [Fig. 4] .
5.
Match the groove on the edge of the desired cutting disc to the pin on the mincing barrel. Slide the
cutting disc on to the feed screw
[Fig. 5] .
6.
Screw the barrel cap on to the end of the mincing barrel until tight [Fig. 6].
7.
Twist the hopper tray into place [Fig. 7] .
Note: Ensure the flat face of the blade faces forwards as illustrated.