Rev. 20220201
4
iArmor
®
Customer Support: [email protected]
(Fig 5) Driver Center/Rear Mounting Bracket Installed
STEP 6
Move to the passenger side of the vehicle. Repeat
Steps 1-5
to
install the passenger side step bar.
Installation completed.
STEP 5
Properly level and adjust the Step Bar and fully tighten all hard-
ware.
STEP 4
Once all (3) driver side mounting brackets are installed, select
and attach the Driver Side Step Bar onto the Mounting Brackets
with (3) U Brackets, (6) Spacers, (3) M8X1.25-55mm Carriage
Bolts, (3) M8 Large Flat Washers, (3) M8 Lock Washers and (3)
M8X1.25 Hex Nuts
(Fig 6)
. Do not fully tighten hardware at this
time.
Attention
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
In order to protect your bars/boards, please use only mild soap/non-abrasive products for cleaning.
NOTE: Torque all M8 X1.25-55mm Car-
riage Bolts to 16~18 Ibs-ft. Don't over
tighten, or the aluminum square bars
will be damaged by the brackets.
(Fig 6) Driver Side Step Bar Installation
Front
M8X1.25-55mm
Carriage Bolt
U Bracket
Spacers
M8 Large Flat Washer
M8 Lock washer
M8X1.25 Hex Nut