FOR 1999-2016 Ford F-250/F-350/F-450/F-550 Super Duty Crew Cab
Rev:20190401
Page 2 of 4
NOTE
: There are (5) mounting locations along the inner body panel. Running Board
installation will use the 2nd,3rd,and 5th mounting locations,
(Figure 1)
.
7.
Repeat
Steps 2—5
to attach (1)Mounting Bracket to the rear location. Do not tighten hardware
at this time.
8.
Select the
Driver Side Bar
. Slip (2) M10X1.5-75 Carriage Bolts into each 2-Hole Support
Brackets ,and insert the 2-Hole support bracket into the
Driver Side Bar
.
(Figure 6)
. Carefully
position the
Bar
onto the (3) Mounting Brackets. IMPORTANT: Do not slide the
Bar
on the
Brackets or damage to the finish may result. Attach the
Driver Side Bar
to the Mounting
Brackets with (2) M10 Hex Nuts,(2)M10 lock washers and (2)M10 flat washers,
(Figure 7)
. Do
not tighten hardware.
9.
Level and adjust the
Bar
properly and tighten all hardware.
NOTE: Torque all M10 X1.5-75
Carriage Bolts to 22~25 Ib-ft. Don't over tighten,or the aluminum square bars will be
damaged by the brackets.
10.
Repeat
Steps 2—9
for passenger/right installation.
11.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
FINISH PROTECTION
Products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect
the finish with a non-abrasive automotive wax, (e.g.Pure Carnauba ) on a regular basis. The use of any soap,
polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to
corrosion.
.
Driver Side Installation Pictured
(Fig 1) Driver/left body mounting locations illustrated back of rocker panel
Front