FOR 1999-2016 Ford F-250/F-350/F-450/F-550 Super Duty Crew Cab
Rev:20190401
Page 1 of 4
PARTS LIST:
Item QTY
Description
Item
QTY
Description
#1
2
Driver/ Passenger Side Bar
#7
18
M10 Large Flat Washers
#2
3
Driver Front Mounting Bracket (DFM/DCM/PRM)
#8
24
M10 Lock Washers
#3
3
Passenger Front Mounting Bracket (DFM/DCM/PRM)
#9
18
M10 Hex Nuts
#4
6
2-Hole Support Bracket
#10
12
M10X1.5-75 Carriage Bolts
#5
6
M10 Clip Nuts
#11
12
M10 Flat Washers
#6
12
M10x1.5- 30mm Hex Bolts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
2.
Starting on the driver side-front of the vehicle, locate the (5) pairs of factory holes along the
bottom of the body, (pinch weld). Move to the 2nd pair of holes directly under the center of the
front door,
(Figures 1 & 2)
. Each mounting location on the inner body panel is comprised of a
rectangular hole with a round hole on each side directly above each pair of holes in the pinch
weld,
(Figures 1 & 3)
.
3.
Select (2) M10 Clip Nuts. Insert Clip Nuts one at a time into the rectangular opening and slide
the threaded hole outward towards the round hole. Line up the threaded hole in the Clip with
the round hole next to the rectangular opening.
NOTE
: Threaded nut must go towards the
inside of the side panel,
(Figures 3 & 4)
.
4.
Partially attach (1) Mounting Bracket to the Clip Nuts with the included (1) M10 x 30mm Hex
Bolts, (1) M10 Lock Washers and (1)M10 Flat Washers,
(Figure 5)
.
NOTE:
Cradles on the
Mounting Brackets should face the front of the vehicle.
5.
Bolt the (2) bottom holes in the Mounting Bracket to the (2) holes in the pinch weld with the
included (1) M10 x 30mm Hex Bolts, (2) M10 Flat Washers, (1) M10 Lock Washers and (1)
M10 Hex Nuts,
(Figure 5)
.
NOTE
: Insert the Hex Bolt with Flat Washer through the pinch weld
first then through the Bracket from the outside to inside. Do not tighten hardware at this time.
6.
Move along the vehicle to the next(Center) mounting location. Repeat
Steps 2—5
to install (1)
Mounting Bracket in the center location. Do not tighten hardware at this time.
DFM/DCM/PRM
2-Hole Support Bracket
PFM/PCM/DRM
