Aprimatic MATIC BOX, Instructions For Use And Installation

Page: 15 / 26

15
6.1 Preparing
6.1.1
Keep trolley locked, pull and push the door by hand, make sure the trolley
connects with the shuttle.
6.1.2
Turn on the power, the courtesy light is on for a several seconds, at the
same time, the LED displays the number from 99 to 11. Then the operator
turns to standby.
6.1.3 At the last, it display "- -
”.
6.2 Setting open and Close Positions
6.2.1 Press and hold SET until
it displays “P1”.
6.2.2 Press SET, it displays
“OP”.
6.2.3 Then press and hold UP, it flashes
“OP” .
6.2.4 When the door has reached the open position, press
SET, it displays
“CL”.
6.2.5
Then press and hold DOWN, it flashes
“CL” . When the door has reached the
closed position, press SET.
6.2.6
The door opens and closes automatically to map the open and close
sensitivity force requirements.
6.2.7 It displays "- -
” to show setting is complete.
6.3 Self Learning Transmitter
6.3.1
When the unit has sto
red 20 codes, it flashes “Fu”, or preventing
coding mistakes, it necessary to cancel all the stored codes.
6.3.2
Press and hold CODE, it displays
“Su”.
6.3.3
Hold more than 8 seconds, it flashes
“dL” , all the codes were
cancelled..
6.4 Adding or Changing Transmitters
6.4.1
Press CODE, it displays
“Su”.
6.4.2
Press a button on the trasmitter, then release and press the same button
again,
“Su” flashes,
6.4.3
The nit displays "- -
” to show setting is complete. Repeat up steps to code a
maximum of 20 different transmitters and/or buttons.
6. Programming the operator