80
use and maintenance RSV mille - RSV mille R
2%-/6).' 4(% 3)$% 34!.$
Carefully read p. 59 (MAINTENANCE).
Only when the vehicle must be used on
racetracks, it is advisable to remove the
stand (1) complete with:
– springs (2);
– support (3);
– safety switch (4).
NOTE
The removal of the safety switch
(4) disconnects the electric circuit; to re-
store it, connect the wiring (6) (aprilia part
# 8124943), which is available at any april-
ia Official Dealer, to the connector (5).
a
CAUTION
Neither lean the vehicle against walls,
nor lay it on the ground.
To park the vehicle without stand (the
removal of the stand is allowed only for
the use of the vehicle on racetracks), al-
ways and exclusively use the rear sup-
port stand
m
.
a
WARNING
It is forbidden to disconnect or remove
the safety switch (4) separately from the
stand.
The disconnection or removal of the
safety switch (4) alone makes it possi-
ble to start the vehicle and leave with
the stand down, which may result in a
fall and in serious injuries to the rider
and other people and damage to the ve-
hicle itself.
For the removal, proceed as follows:
◆
Remove the left side cover, see p. 78
(REMOVING THE SIDE COVERS).
◆
Remove the lower fairing, see p. 77 (RE-
MOVING THE LOWER FAIRING).
◆
Lift the fuel tank, see p. 76 (LIFTING
THE FUEL TANK)
NOTE
Prepare a clamp (7) to be used
for the reassembly.
a
CAUTION
Do not force cables, pipes, connectors
and wires.
◆
Cut the clamp (8) and release the cable
(9).
◆
Disconnect the electric connector (10)
from the connector (5).
◆
Connect the wiring (6) (aprilia part #
8124943) [replacing the electric connec-
tor (10)].
3
1
5
6
2
4
RSVmille-R-UK.book Page 80 Friday, November 17, 2000 3:13 PM
