use and maintenance
Classic 125
49
!$*534).'
4(% (%!$,)'(4 "%!-
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height, see Fig. 50).
To adjust the headlight beam, proceed as
follows:
◆
Loosen the screw (1 - Fig. 51).
◆
Turn the headlight and adjust the beam.
◆
Tighten the screw (1 - Fig. 51).
"5,"3
Before changing a bulb, turn the
ignition switch to position "
m
".
Change the bulb wearing clean
gloves or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to prevent it from blowing fre-
quently.
Carefully read page 32 (MAINTENANCE).
DO NOT FORCE THE ELECTRIC
CABLES
#(!.').'
4(% (%!$,)'(4 "5,"3 &IG
Carefully read p. 32 (MAINTENANCE)
and p. 49 (BULBS).
To change the bulbs, proceed as follows:
◆
Unscrew and remove the screw (1 -
Fig. 51).
◆
Remove the headlight and unscrew the
two screws (1 - Fig. 52).
◆
Grasp the lower part of the parabolic ele-
ment, which will rotate until it is released.
The low beam/high beam bulb socket (larg-
er) must be rotated anticlockwise; the park-
ing light bulb socket (smaller) must be with-
drawn.
Extract the bulb socket and replace the
damaged bulb.
Fig. 50
H
Fig. 51
a
Fig. 52
