UIM
ip
- TAD
6 / 19
02.03.2017
4.1.2
F
UNCTION
B
UTTON AND
F
ACTORY
R
ESET
The function button ( ) is used to execute a factory reset of the
UIM
ip
.
The factory reset is carried out by pressing the button for about 15 seconds (LEDs 1, 2 light
orange). After release, pressing it again until all LEDs turn off resets all parameters
to factory default settings (incl. physical address). Subsequently, after the automatic restart
of the device LEDs 1, 2 light green again indicating the normal operation status.
1.
Long press of the function button (≈ 15 s) in “Normal Mode”
2.
Short press of the function button (≈ 3 s)
4.2
B
OOT
M
ODE AND
F
IRMWARE
U
PDATE
As described for the “Normal Mode” the same factory reset procedure applies when the device
is in “Boot Mode”. Additionally, the
UIM
ip
exits the “Boot Mode” afterwards.
1.
Long press of the function button (≈ 15 s) in “Boot Mode”
2.
Short press of the function button (≈ 3 s)
When operating in “Boot Mode”, it is possible to update the
UIM
ip
’s firmware.
For more detailed information concerning the update procedure please refer to the section
. In order to switch from “Normal Mode” to “Boot Mode” it is necessary to begin
the firmware update procedure and use the “Request Update” button in the
1.
Press the programming button in “Normal Mode”
2.
Press the function button
3.
Press the “Refresh” button in the Update tab of the Web front-end
4.
Press the “Request Update” button
While being in “Boot Mode” LED 1, 2 and 5 have the states as described here:
LED 1 Bus State LAN
Keeps on lighting green
LED 2 Bus State KNX
Blinking green
LED 3 Traffic LAN
Blinking green
LED 5 Programming
Keeps on lighting red
In general, there are three options to switch from “Boot Mode” back to “Normal Mode”:
Update the firmware (if you have a new firmware available for your
UIM
ip
).
Cancel the update procedure and reset the application by pressing the “Abort” button.
Wait 10 minutes until the device switches to “Normal Mode” automatically by itself.
B