Avia Pole-mount Monitor Arm Assembly Instructions
Page 3 of 3
Adjusting the torque:
1. Remove joint cap (L) from the top of the joint using a small flat
head screw driver.
2. Unscrew the cable manager (M) from the bottom of the joint.
3. Holding the bolt in the top of the joint with a 9/16” socket, use a
second 9/16” socket on the nut in the bottom of the joint to adjust
the torque setting.
4. Replace cap and reassemble cable manager.
Using the Height Adjustable Cable Manager:
1. Remove cable manager (N) by pinching at release points.
2. Lay cables in cable manager.
3. Snap cable manager back into place. Note text indication
“FRONT” inside cable manager.
Mounting the Monitor:
Quick Connect Bracket:
1. Affix Quick Connect Bracket to screen, make sure
arrow is pointing up.
2. Make sure faceplate arrow is also pointing up then slide
monitor mount assembly onto faceplate until bottom tab
clicks onto faceplate.
3. To remove the monitor, depress tab and remove from
monitor mount assembly.
Adjusting the Tilt Tension:
If the monitor drops or is too tight, adjust the tension screw at the side
of the head as shown using the 3/16” Allen key.
i
1
2
3401 Madison Street
Skokie, IL 60076
(847) 679-5148