Avia Pole-mount Monitor Arm Assembly Instructions
Page 2 of 3
Mounting pole to work surface using
the Grommet Mounting System:
1. Use Phillips screw driver to remove the screws which
attach the upper clamp bracket (J) to pole base.
2. Assemble lower clamp bracket (H) to furthest slots
on upper clamp bracket (J) to align clearance holes.
3. Slide knob (j) on to bolt (K) (long 3/8” bolt).
4. Lay monitor cables through grommet holes in the work surface.
5. Align pole on work surface.
6. Install bolt (K) through the clearance holes on clamp bracket (J)
insert the threaded end through the grommet and into the pole
base, using knob (j) to tighten securely.
7. For applications requiring increased tightness, remove knob
from bolt head and using a 9/16” wrench tighten the bolt
to 90 in-lbs. Caution: DO NOT OVERTIGHTEN
Adjusting the Height Adjustable Segment:
1. Remove the plastic shroud on the side of the height
adjustable segment.
2. With the monitor mounted to the arm, move the monitor through
the height range; Ensure the arm will hold the monitor in the
position you placed it.
3. If the monitor drops or rebounds upward, adjust the tension screws at the front
and back of the arm segment as shown using the 3/16” Allen key. Repeat steps
until the monitor is counterbalanced.
Mounting pole to work surface using the Clamp Mounting System:
1. Slide knob (j) on to bolt (l) (short 3/8” bolt), ensuring the bolt head is
securely engaged into the knob.
2. Screw bolt (l) in to the lower clamp bracket (H) and using clamp pad
screw (r) attach clamp (k) to the end of the bolt (I).
3. Hook lower clamp bracket (H) in to one of the top 2 (of the 3)
positions provided.
4. Position clamp bracket and pole assembly (F) onto work surface in
desired location.
5. Using knob (j) tighten securely.
6. For applications requiring increased tightness, slide knob up bolt to expose
the bolt head and using a 9/16” wrench tighten the bolt to 90 in-lbs.
Caution: DO NOT OVERTIGHTEN