~ 32 ~
QUICK CHECK
After replacing any components, you should have a quick check without laundry in the unit, in order to
make sure the unit will work normally by following the next steps.
Checking the Wash Cycle
:
Turn the program dial to Towels position, and then press the
START/PAUSE button. The unit will start to filling in with the water from both inlet valves. After some
minutes, it will stop to fill when the water level reaches to the set value, and the drum will start to agitate.
Then press the START/PAUSE button again, turn the program dial to the Spin only position and press the
START/PAUSE button, the unit will pump the water out and begin to spin simultaneously
.
Checking the Dry Cycle
:
Select the venting dry function by pressing the Venting/Condensing
button. Turn the program dial to Full Heat position, and press the Time- button to reduce the dry time until
it is less than 60 minutes, then press the START/PAUSE button. The unit will start to heat up and you can
sense the hot air nearby the venting fan.
※
Please Note
:
In this unit the door can’t be opened in washing cycle unless
and until the unit is power off and in 2 minutes. However the door can be opened
at any time after the lock-opening symbol displayed on the VFD in the drying
cycle.
Summary of Contents for 4000
Page 28: ... 27 Appendix 2 Option Buttons and Graphic Display ...
Page 29: ......
Page 30: ... 29 Appendix 4 Wiring Diagram ...
