Appleton • 1.800.621.1506 • www.appletonelec.com
650457-000 Rev. E 05/13 • Page 3 of 8
Mounting Hoods
Pendant (KPA-75, KPA-100, KPAF-75, KPAF-100)
Mounting:
1.
Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit stem. thread the pendant hood onto
the 3/4 inch or 1 inch conduit stem.
2.
tighten the set screw inside the hood.
CEILING
PENDANT HOOD
JCT BOX
CONDUIT
STEM
SET SCREW
(INSIDE HOOD)
Pendant Cone (KPCH-75, KPCH-100)
Mounting:
1.
Apply tlc-3 grease in approximately three equal lines, spaced equally apart on the conduit stem. thread the pendant cone hood
onto the 3/4 inch or 1 inch conduit stem.
2.
tighten the set screw.
CONDUIT STEM
SET SCREW
Ceiling (KPC-75, KPC-100)
Mounting:
1.
Bolt the ceiling hood directly to a structural member; thread onto a 3/4 inch or 1 inch conduit stem;
or bolt to a flush mounted
junction box (see notEs).
2.
Remove unused conduit plugs and reinstall with tlc-3 grease applied in approximately three equal lines, spaced equally apart on
the conduit plugs.
CONDUIT ENTRIES (5x)
NOTES:
• four drill marks on the 3-1/2 inch pitch diameter are provided for junction box mounting.
• install the junction box gasket (supplied) between the junction box and the ceiling hood.